|
|
|
|
|
|
|
|
|
|
|
Additional changes as follows shall apply as requested by Manufacturer Glenair and as discussed and agreed with other supporting Manufacturers, C&K, Axon, in order to be consistent across all 3 Manufacturers:
see attached "ESCC3401032Iss12D in review per DCR" for full change details (changes highlighted by text colour).
Table 1(a):
- Description fields for several Variants are amended to clarify shell size 51, 69 is applicable.
- Add new Note 2 to the "For Use With" column as follows:
"2. The applicable shell sizes are the same as given in the description column (if specified in the referenced specification)."
Figure 2 (as applicable):
Amend figure titles for the same Variants as in 1) above, to match the modified descriptions in Table 1(a).
Add new figures.
Figure 2 for Variant 10: Correct the clip spacing in the centre bottom figure to be 2.55 ±0.15mm (was 2.9 ±0.2mm).
Note for information: The same clip spacing dimension for Variant 07 was corrected from 2.9 ±0.2mm to 2.55 ±0.15mm in DCR1101.
New Figure 2 for Variants 49 to 53: Variants listed in table are corrected.
New Figure 2 for Variants 54 to 58: Variants listed in table are corrected.
New Figure 2 for Variants 41, 43, 48, 54 to 58, the torque values for the male & female sides given in each figure, are corrected.
|
|
|