As an addition to this DCR, for consistency & clarification purposes,the following changes shall be made:
Delete all references to coaxial contacts (as coaxial contacts for this specification are not actually specified within the referenced ESCC Detail specs for associated contacts (3401/009 & 3401/012)).
i.e. additional proposed changes are:
- Page 13, Figure 2(b): delete "or coax" where stated from all relevant images; e.g. 3-01, 61-949, etc.
- Page 18 Para 4.5.4:
Remove characteristic "(h) Contact dash number" and "Contact dash number: 1" from the lists (plus Modification bullet to be relabeled as "(h)".
- Page 20, Para 4.5.4.7: Contact Dash Numbers paragraph to be deleted in full (other paragraphs to be renamed accordingly).
………………………
Page 18 Para 4.5.4:
Add the standard ordering modification code "090" to the given example and bullet and add a note to bullet (i).
Change the "xxx" example given to an actual modification code "031".
i.e.:
Example: DBAS76G19-2PNDA090-031
(i) Modification (see Para. 4.5.4.8(a))
- Modification: 090-031
………………………
New Para. 4.5.4.8 Key Orientation: Add clarification for the definition of the component number and the marking when the standard key orientation is required.
i.e. Add the following:
"For the specified standard key orientation, no code applies; no code shall appear."
………………………
Page 21, Amended Para. 4.5.4.9 Modification Codes:
Split the paragraph into bullets, a, b, c, d, for each of the different items.
i.e.
Amend as follows:
4.5.4.8 Modification Codes
Modification codes shall be expressed in letters, numbers, or both. When there is no modification of the standard product, no code shall appear.
The following modification codes are applicable in the following order of precedence:
(a) Delivered Without Contacts - Code 090
These high reliability connectors are always ordered and delivered separately from the contacts. This code shall never appear on the connector itself, but shall be used for ordering purposes and in documentation.
(b) Black Anodise Treatment - Code 031
(c) Delivered Without Nut - Code 1A
Note: see also codes E5624 and L5624 in (d) below.
(d) Cable Length for Plug with Lanyard - Code as below
The cable lengths for shell type 78 are designated by the following modification codes:
Modification Code // Cable Length (mm) // Remark
(put amended table here including codes E5624 and L5624 with remarks:
E5624 = Same as code E614; delivered without nut
L5624 = Same as code L614; delivered without nut)
|
Login
